Nokia 3520 - . ADDITIONAL SAFETY INFORMATION

82

Copyright © 2004 Nokia

Vehicles

RF signals may affect improperly installed or inadequately shielded electronic systems
in motor vehicles such as electronic fuel injection systems, electronic antiskid
(antilock) braking systems, electronic speed control systems, air bag systems. For
more information, check with the manufacturer or its representative of your vehicle
or any equipment that has been added.

Only qualified personnel should service the device, or install the device in a vehicle.
Faulty installation or service may be dangerous and may invalidate any warranty
that may apply to the device. Check regularly that all wireless device equipment in
your vehicle is mounted and operating properly. Do not store or carry flammable
liquids, gases, or explosive materials in the same compartment as the device, its
parts, or enhancements. For vehicles equipped with an air bag, remember that an
air bags inflate with great force. Do not place objects, including installed or portable
wireless equipment in the area over the air bag or in the air bag deployment area.
If in-vehicle wireless equipment is improperly installed and the air bag inflates,
serious injury could result.

Potentially explosive environments

Switch off your device when in any area with a potentially explosive atmosphere
and obey all signs and instructions. Potentially explosive atmospheres include areas
where you would normally be advised to turn off your vehicle engine. Sparks in
such areas could cause an explosion or fire resulting in bodily injury or even death.
Switch off the device at refuelling points such as near gas pumps at service stations.
Observe restrictions on the use of radio equipment in fuel depots, storage, and
distribution areas, chemical plants or where blasting operations are in progress.
Areas with a potentially explosive atmosphere are often but not always clearly
marked. They include below deck on boats, chemical transfer or storage facilities,
vehicles using liquefied petroleum gas (such as propane or butane), and areas
where the air contains chemicals or particles such as grain, dust or metal powders.

FCC regulations prohibit using your wireless device while in the air. The use of
wireless telephones in an aircraft may be dangerous to the operation of the
aircraft, disrupt the wireless telephone network, and may be illegal.

Failure to observe these instructions may lead to suspension or denial of telephone
services to the offender, legal action, or both.

EMERGENCY CALLS

Important: Wireless phones, including this phone, operate using radio signals,
wireless networks, landline networks, and user-programmed functions.
Because of this, connections in all conditions cannot be guaranteed. You
should never rely solely on any wireless phone for essential communications
like medical emergencies.

Nokia

3520 and Nokia 3560 User Guide

83

Copyright © 2004 Nokia

Reference Information

To make an emergency call:

1

If the phone is not on, switch it on. Check for adequate signal strength.

2

Press the End key as many times as needed to clear the display and ready the
phone for calls.

3

Key in the official emergency number for your present location. Emergency
numbers vary by location.

4

Press the Talk key.

If certain features are in use, you may first need to turn those features off before
you can make an emergency call. Consult this guide or your service provider. When
making an emergency call, give all the necessary information as accurately as
possible. Your wireless phone may be the only means of communication at the
scene of an accident. Do not end the call until given permission to do so.

84

Copyright © 2004 Nokia

CERTIFICATION INFORMATION (SAR)

THIS MODEL PHONE MEETS THE GOVERNMENT'S REQUIREMENTS FOR EXPOSURE
TO RADIO WAVES.

Your wireless phone is a radio transmitter and receiver. It is designed and manufactured
not to exceed the emission limits for exposure to radio frequency (RF) energy set
by the Federal Communications Commission of the U.S. Government. These limits
are part of comprehensive guidelines and establish permitted levels of RF energy
for the general population. The guidelines are based on standards that were developed
by independent scientific organizations through periodic and thorough evaluation
of scientific studies. The standards include a substantial safety margin designed to
assure the safety of all persons, regardless of age and health.

The exposure standard for wireless mobile phones employs a unit of measurement
known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is
1.6W/kg.* Tests for SAR are conducted using standard operating positions accepted
by the FCC with the phone transmitting at its highest certified power level in all
tested frequency bands. Although the SAR is determined at the highest certified
power level, the actual SAR level of the phone while operating can be well below
the maximum value. This is because the phone is designed to operate at multiple
power levels so as to use only the power required to reach the network. In general,
the closer you are to a wireless base station antenna, the lower the power output.

Before a phone model is available for sale to the public, it must be tested and certified
to the FCC that it does not exceed the limit established by the government-adopted
requirement for safe exposure. The tests are performed in positions and locations
(for example, at the ear and worn on the body) as required by the FCC for each
model. The highest SAR value for this model phone as reported to the FCC when
tested for use at the ear is 1.24 W/kg (3560) and 1.26 W/kg (3520), and when worn
on the body, as described in this user guide, is 0.75 W/kg (3560) and 0.70 W/kg
(3520). (Body-worn measurements differ among phone models, depending upon
available enhancements and FCC requirements).

While there may be differences between the SAR levels of various phones and at
various positions, they all meet the government requirement.

The FCC has granted an Equipment Authorization for this model phone with all reported
SAR levels evaluated as in compliance with the FCC RF exposure guidelines. SAR
information on this model phone is on file with the FCC and can be found under the
Display Grant section of http://www.fcc.gov/oet/fccid

after searching on FCC ID

GMLRH-14/GMLRH-21.

Nokia

3520 and Nokia 3560 User Guide

85

Copyright © 2004 Nokia

Reference Information

For body worn operation, this phone has been tested and meets the FCC RF exposure
guidelines for use with an enhancement that contains no metal and that positions the
handset a minimum of 7/8 inch (2.2 cm) from the body. Use of other enhancements
may not ensure compliance with FCC RF exposure guidelines. If you do not use a
body-worn enhancement and are not holding the phone at the ear, position the handset
a minimum of 7/8 inch (2.2 cm) from your body when the phone is switched on.

*In the United States and Canada, the SAR limit for mobile phones used by the
public is 1.6 watts/kilogram (W/kg) averaged over one gram of tissue. The standard
incorporates a substantial margin of safety to give additional protection for the
public and to account for any variations in measurements. SAR values may vary
depending on national reporting requirements and the network band. For SAR
information in other regions please look under product information at
www.nokia.com/us.